Thermo Scientific DensityPRO, Application Manual

Page: 41 / 101

Chapter 5
Standardization & Calibration
This chapter provides an overview on how to use the NI-FBUS
Configurator menus to standardize and calibrate the DensityPRO.
Note This chapter provides setup instructions using the NI-FBUS
Configurator menus, as this is the preferred way to configure the
instrument. Move from one step to the next in the configurator method
window by clicking
Next or pressing Enter . If your host does not support
menus, reference Appendix C for a list of DensityPRO parameters. ▲
Note For detailed discussion on standardization and calibration, reference
the DensityPRO user guide (P/N 717784). ▲
Perform
Standardization
Follow this procedure to perform standardization:
1. Put the gauge head and pipe in one of the following standard
configurations. Use the exact same standard configuration every time
you standardize.
a. Pipe full of carrier
b. Pipe empty
c. Pipe full of process
2. Open the source shutter.
3. In the NI-FBUS Configurator, go to AI_TRANSDUCER > Root
Menu > 2 Standardization > Standardization.
4. When prompted, remove the loop from automatic control.
Thermo Fisher Scientific DensityPRO with F
OUNDATION
™ fieldbus Application Guide 5-1