Thermo Scientific DensityPRO NAI Series, User Manual

Page: 57 / 196

Operation
System Control
Thermo Scientific DensityPRO User Manual 4-5
Configuration
The System Control Configuration screen provides the user with the ability to set up
system parameters related to items such as the system clock and the LCD screen. The
gauge should be able to read and write any of these parameters as requested by the user.
To access the information on the System Control Configuration screen using only the
remote transmitter keypad, see
Figure A-2 .
1. Set the system date and time.
a. Choose the desired date format. The available options are:

MM/DD/YY

DD/MM/YY

YY/MM/DD
b. In the System Date textbox, enter the current date.
c. Enter the current time in the System Time textbox, using the format
HH:MM:SS.
To synchronize the date and time of the DensityPRO system with that of the PC
in use, check the Use PC Date/Time textbox.
2. The LCD scroll time dictates the length of time information takes to scroll across
the LCD screen. If the system in use is an integrated system, enter the desired
scroll time in the Integrate Scroll Time (sec) textbox. If the system in use is a
remote system, enter the desired scroll time in the Remote Scroll Time (sec)
textbox.
3. The LCD contrast can be adjusted on the Remote unit by adjusting the LCD
Contrast value. The value can range from 0 – 99.
Note: At this time, it is strongly recommended that configuration information
be saved to your computer. If the work has been completed off-line, connect
to the density gauge via one of the serial ports and upload the configuration
file to the gauge.