Thermo Scientific DensityPRO NAI Series, User Manual

Page: 37 / 196

Startup & the Setup Wizard
System Timeout
Thermo Scientific DensityPRO User Manual 3-7
The fields representing the inputs will display the current operational mode of
each port. If the user connects to the gauge through Com A and enters the
Engineer mode password, Com A Password Mode will display Engineer, while the
other port fields say Display List.
– The Mode Count fields indicate how many times the gauge has been accessed in
each respective mode.
– The passwords for the different access levels may be changed by manually
changing them in the Password Setup section of this screen.
Note: Passwords must be numeric only so as to be accessible when working at
the keypad display.
System Timeout
If a user does not interact with the gauge for five minutes, the display will time out and
begin showing the scrolling measurement screens. Each time a button on the keypad is
pressed or the user interacts with the EZ Cal II software, the timeout period resets to
five minutes.
During standardization and calibration the timeout function is inactive and will not
occur.
The Setup
Wizard
Begin the density setup using the setup wizard. To start the wizard, click on the small
blue wizard’s cap on the task bar, underneath the View menu option.
Figure 3-3. Detector and Application Type Selection