Thermo Scientific Corona Veo, Operating Manual, Page: 114 / 262

6 • Operation
Page 114 Charged Aerosol Detectors Corona Veo (RS) Operating Manual
6.4.2.3
Evaporation Temperature Screen
The Evaporation Temperature screen provides the means to set and
monitor the temperature of the evaporation tube. To adjust a
parameter, select the respective parameter in parenthesis.
If no errors or warnings are active, the
Status is Normal .
Figure 22: Evaporation Temperature screen (here: Corona Veo RS)
Parameter Description
Temperature Displays the actual evaporation temperature (read-only)
TIP The actual temperature reached depends on several factors,
including mobile phase composition, liquid flow rate, mobile phase
temperature, gas temperature, and ambient temperature.
Setpoint Allows setting the evaporation temperature
The default evaporation temperature is set to 35 °C.
TIP Before you start sample analysis, wait approximately 30 minutes
after you changed the temperature setpoint to ensure that the
evaporation tube comes to equilibrium for the set temperature.
The available temperature settings depend on the detector:
Detector Temperature setpoints
Corona Veo: Selectable values: 35 °C or 50 °C
Corona Veo RS: Settable range: a5 °C to +100 °C, in
0.1 °C steps
Power Turning on or off the temperature control for the evaporation tube