212A Modem Option
Installation
8-2 AutoPILOT PRO Flow Computer User Guide
Thermo Fisher Scientific
To install the 212A modem assembly into the flow computer enclosure,
follow the steps below.
Warning
Ensure the area is non-hazardous before connecting or
disconnecting the modem.
1.
Open the enclosure door. Loosen the thumbscrews on the mounting
bracket, and lift the main board and mounting bracket up.
2.
Refer to Figure 8–1 for the following. Refer to the
general assembly
drawing
for assembly orientation and mounting location.
a.
Place one star lock washer over each mounting hole on the support
bracket, and then insert a 3/8-inch standoff.
b.
Align the modem onto the bracket, and secure it using the star lock
washers and 1/2-inch standoffs.
c.
Mount the assembly onto the chassis bracket using the screws
provided.
Figure 8–1. 212A modem mounting (chassis bracket not shown)
3.
Connect the modem ground (E1) to the ground stud at the bottom of
the flow computer enclosure.
Installation