Thermo Fisher Scientific
AutoPILOT PRO Flow Computer User Guide 3-1
Chapter 3
Installing the Basic System
This chapter provides mounting and wiring instructions for the basic
AutoPILOT PRO system. In addition to the material in this chapter,
reference
for associated drawings and wiring diagrams.
Tip
Installation instructions for the
at the end of this chapter. All other options are addressed in their own
chapter. For example, installation of MEBs is addressed in
This configuration has been evaluated to conform to UL, Canadian,
ATEX, and Brazilian standards. Refer to the appropriate certification tag
for ratings.
For United States installations, wire all circuits connected to the flow
computer (unless otherwise specifically identified) using the Class I, Div. 2
Wiring Methods specified in Article 501-4(b) of the National Electric
Code, NFPA 70.
For Canadian installations, wire all circuits connected to the flow computer
(unless otherwise specifically identified) using the Class I, Div. 2 Wiring
Methods specified in Section 18-152 of the Canadian Electrical Code.
For European installations, wire all circuits connected to the flow computer
(unless otherwise specifically identified) using methods specified in the
European Standard EN60079-14.
For Brazilian installations, wire all circuits connected to the flow computer
(unless otherwise specifically identified) using methods specified in IEC
60079-14.
Warning
Do not make or break any connections while circuit is active.
Warning
Ensure the area is non-hazardous before making any
connections.
Warning
Customer equipment and devices must be suitable for the location
where they are to be installed.
General
NEMA 4X / IP65
