Thermo Scientific AquaSensors
™
DataStick
™
Ethernet Communications User Guide
6
1 Quick Start
If you’re familiar with setting a computer’s IP address and have a cross-over cable and a
power injector, the quickest way to establish communications with a Thermo Scientific
AquaSensors Ethernet product is to:
Figure 1: A diagram of an isolated Ethernet DataStick network.
Figure 2: A diagram of an isolated AV38 network.
1.
Change the computer’s IP address to 192.168.0.1.
2.
Plug the product into the PoE-side of the power injector.
3.
Connect the power injector to the computer using a CAT5 cross-over cable.
4.
Point your Web browser at 192.168.0.100 to see the Home Page.
The Home Page will show the product’s measurement values, configuration and
diagnostic information. From there, the product’s IP address can be changed if desired
by clicking on the CommSettings button.
If you’re not familiar with setting a computer’s IP address, see Section 3 for a detailed
description of the configuration procedure.
