3
Commissioning:
Fault Finding:
1. Turn on the electrical supply.
2. Set the switch to l
3. Turn on the central heating system.
4. Set any room thermostat/s to maximum.
5. Set the switch to l – the fan should run and
heat will flow within a few minutes if water
temperature in the system is more than 40°C.
6. Balance the central heating system if Kitchen
plinth heater is installed on the same circuit as
panel radiators.
7. When the installation is working correctly,
remember to reset any room thermostat/s to its
normal setting
1. Fan does not run on any
switch setting.
a). Check the power supply is switched ON.
b). Check the switch has turned ON.
2. No heat output.
a). Check the power supply is switched ON.
b). If fitted, ensure any room thermostats are calling for heat.
c). Balance the central heating system if installed on same circuit
as panel radiators and increase the circulating pump speed if
required.
d). Increase the boiler water temperature.
5. Position heater, making sure the
flexible hoses is not kinked and the
electrical cable is not snagged.
Electrical Cable
Plinth
HOSE
BEND RADIUS
60mm MIN
6. Fix the heater to plinth
using fixing screw holes
located at either end of grille.
I
O
II
Grille to plinth securing
screws
