Thermal Dynamics cutskill 35A, Operating Manual

Page: 25 / 40

cutSKILL 35A
June 30, 2009 4-5 OPERATION
NOTE
Minimum pressure for power supply op-
eration is lower than minimum pressure for
torch operation.
4. Wear protective clothing, including welding
gloves and appropriate eye protection (see table
1-1). Place tip on work piece and pull trigger.
Arc will initiate and start cutting material.
• Standoff Cutting With Hand Torc h
NOTE
For best performance and parts life, always
use the correct parts for the type of opera-
tion.
A. The torch can be comfortably held in one
hand or steadied with two hands. Position
the hand to press the Trigger on the torch
handle. With the hand torch, the hand may
be positioned close to the torch head for
maximum control or near the back end for
maximum heat protection. Choose the hold-
ing technique that feels most comfortable
and allows good control and movement.
NOTE
The tip should never come in contact with
the workpiece except during drag cutting
operations.
B. Depending on the cutting operation, do one
of the following:
a).
For edge starts, hold the torch
perpendicular to the workpiece with
the front of the tip on the edge of the
workpiece at the point where the cut is
to start.
b). For standoff cutting, hold the
torch tip on the work piece, pull the trig-
ger. After the arc is initiated lift the tip to
1/8" - 3/8" (3-4mm) off the work.
A-00024_AB
Shield Cup
Torch
Standoff Distance
1/8" - 3/8" (3 - 9mm)
Standoff Distance
Art # A-03962
Trigger
Trigger Release
3
4
Art # A-03383
Trigger
2
1
Trigger Release
ARC WELDING SUPPLIES - 07 847 7870