Thermal Dynamics 1-4200-6, Operating Manual, Page: 13 / 44

CUTMASTER 10MM, 12MM
Manual 0-5197AD 2-1 SYSTEM INTRODUCTION
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Operating Manual applies to just specification or part
numbers listed on page i. To ensure safe operation, read the
entire manual, including the chapter on safety instructions
and warnings. Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular attention to
the information provided under these headings. These special
annotations are easily recognized as follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be purchased by contact-
ing Thermal Dynamics at the address and phone number in
your area listed in the inside back cover of this manual. Include
the Operating Manual number and equipment identification
numbers.
Electronic copies of this manual can also be downloaded at no
charge in Acrobat PDF format by going to the Thermal Dynamics
web site listed below and clicking on Thermal Dynamics and
then on the Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identification
The unit’s identification number (specification or part number),
model, and serial number usually appear on a data tag attached
to the rear panel. Equipment which does not have a data tag
such as torch and cable assemblies are identified only by the
specification or part number printed on loosely attached card
or the shipping container. Record these numbers on the bottom
of page (i) for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for pos-
sible damage due to shipping. If there is any damage, notify the
carrier immediately to file a claim. Furnish complete information
concerning damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual.
Include all equipment identification numbers as described above
along with a full description of the parts in error.
Move the equipment to the installation site before unpacking
the unit. Use care to avoid damaging the equipment when using
bars, hammers, etc., to unpack the unit.
2.04 Working Principle
Rectifier
Inverter
Transformer
Rectifier
Reduce pressure, filter Gas valve Cutting torch
Workpiece
Compressed air
Art # A-09204_AB