29
MANUAL 0-2510
3.02 Setup for Operation
Gas Metal Arc Welding (GMAW)
WARNING
Read and follow all safety precautions on pages 2-5 of this manual before
preceding with operation.
1.
Install and connect unit according to the installation instructions in
section 2.04, page 17, of this manual.
2.
Install and connect wire feed system according to its Owners
Manual. Connect the wire feeder to the POSITIVE output terminals.
3.
Wear dry insulating gloves and clothing.
4.
Connect work clamp to clean, bare metal on workpiece. For the
majority of electrodes in use, the work clamp is connected to the
NEGATIVE output terminal.
5.
Place the PROCESS SELECTOR switch [4] in MIG position.
6.
Place the OUTPUT CONTACTOR switch [8] in REMOTE position.
7.
Place the AMPERAGE/VOLTAGE switch [11] in the desired
position.
1
4
11
7
3
8
8.
Rotate AMPERAGE/VOLTAGE control [1] to desired position.
9.
Rotate ARC CONTROL/INDUCTANCE control [3] to desired
position.
10. Turn on shielding gas supply and set desired flow rate.
11. Wear welding helmet with proper filter lens according to ANSI
Z49.1.
12. Place PRIMARY POWER switch [18] in ON position.
13. Begin welding.
SETUP FOR OPERATION
Summary of Contents for Thermal Arc 400GMS CC
Page 16: ...14 MANUAL 0 2510...
