Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 52 of 68
Figure 97: Bracket (Typical Model Shown) and Insulation
Figure 98: Screws Connecting Bracket to Motor
13. Replace the convection motor, if needed.
NOTE:
When installing, the front cover must be positioned with
the cover vents facing to the right (see Figure 91).
6.5 Removal and Replacement of Front-Accessible
Components
This section contains removal and replacement procedures for the
components that can be accessed from the front of the range.
6.5.1
Control Panel Removal and Replacement
Figure 99: Control Panel
The following procedures for removal and replacement of the control
panel are provided primarily in the event the control panel is damaged
and needs replacing. Most components can be accessed and
serviced without the need to remove the control panel.
NOTE:
When removing and replacing the control panel, you must first
disconnect all wire and harness connections, and remove all manifold
support brackets connected to the back side of the control panel.
1. Follow all safety precautions and steps in
, page
2. Follow all steps in
Accessing Components under the Maintop,