EX-TRAFIRE
®
40SD
Operator Manual, Revision T-15
2-13
Specifications: Torch FHT-EX
®
40
Torch
Torch FHT-EX
®
40H
Recommended capacity
12 mm*
Maximum capacity
20 mm*
Piercing capacity
8 mm*
Plasma cutting
- 10 °C to + 40 °C
Transport and storage
- 25 °C to + 55 °C
Relative humidity
up to 90 % at 20 °C
Application process
plasma cutting
Type of use
manual and mechanized
Pilot current
10 A -18 A
Rated current and corresponding duty cycle
40 A/100%
Type of gas
compressed air
Gas flow rate
approx� 120 l/min
Operating (dynamic) pressure
4�5 bar
Min�/Max� operating pressure
3�5-5�0 bar
Gas post flow delay
≥ 20 sec�
Type of voltage
DC direct voltage
Protection type of the machine-side connections
IP3X (EN 60 529)
Type of connection
TCS (torch connection system) - 13 pin
Voltage rating
500V peak value
Rated value of control leads (trigger and cap sensor)
42 VAC / 0�1-1A
Standard lenght (other length availible on request)
4 m / 5 m / 7�5 m / 15 m
Structure of cable
(Bikox) compact cable
*
Cutting capacity (Values for low alloyed steel, e�g� Mild Steel S235JR)
Weight
FHT-EX
®
40 Hand Torch
4 m / 1�2 kg
5 m / 1�4 kg
7�5 m / 1�8 kg
15 m / 3�2 kg
FHT-EX
®
40 Machine Torch
4 m / 1�2 kg
5 m / 1�4 kg
7�5 m / 1�8 kg
15 m / 3�2 kg
The FHT-EX
®
manual cutting torche is designed for plasma cutting of metalic conductive materials�
Torch construction: torch body, handle, leadset and consumables�
FHT-EX
®
torches fulfill the requirements of IEC/EN 60974-7�
Summary of Contents for EX-TRAFIRE 40SD
