Tools Needed
– Phillips Head Screwdriver, 7/16
Wrench or Pliers or Adjustable Wrench. Flat surface
to work on (table preferred)
Parts List-
1 Fabric Mat
4 lengths of PVC or Alum slotted pipe (2 long & 2
short)
4 PVC or Alum legs
4 top corners – 4 bottom corners
4 leg caps, 8 machine screws & 8 locknuts
4 pieces white plastic cording (shipped inside bed
frame for Ballistic fabrics
)
NOTE: 40 oz Vinyl fabrics have the cording
already encased in outer edge of fabric
XX Large (50 x 35) & X Large (44 x 27) size beds
utilize metal reinforcing pipes which are inside the
long side pipe.
3. Working from underneath, position one top
corner fitting and insert bolt through fitting
and pipe. Place a bottom fitting in
position, secure with a lock nut and hand
tighten. Insert and secure second bolt.
Repeat process at other three corners.
XX Large (50 x 35) & X Large (44 x 27) beds
have reinforcing pipes that may shift inside
frame during shipping and block a bolt hole.
Tap frame on floor or use a hammer &
screwdriver to centre the pipe between holes.
1. Lay fabric flat with underside facing up and
insert cording into sleeves. See note above for
new heat welded fabrics.
2.
Insert fabric sleeves into the channel on each
length of pipe.
4. Place rubber caps on legs and insert legs
into corners. Turn bed over and tighten
each bolt and nut on each corner.
NOTE:
TIGHTEN PROPERLY – correct
tightening will leave end of bolt flush with the
nuts’ white nylon locking material.
INSUFFICIENT OR OVER TIGHTENING OF
THE CORNERS MAY RESULT IN
CRACKING.
Easy Assembly Instructions For Kuranda Standard Poly-Resin Beds
Comments or Questions? Call Therian on 1800 251 766
