Thenow HSN-J15-Z, User Manual, Page: 23 / 26

２３
1 、 Using Requirements
(1) Working conditions: Surrounding temperature at 5
℃
-35
℃
, relative humidity lower than 80% ;
(2) Please make certain power supply is specified voltage, it’s strictly prohibited to operate equipment with phase
missing or under voltage
；
(3) If the equipment has not been used for a long time ,please make sure to turn off the power.
2 、 Cleaning and Replacing
Disconnect electric power from the appliance before any operation, otherwise there will
be the risk of electric shock.
Because the temperature probe is a sensitive element,in dusty place,please use low pressure water to clean
regularly (for example,with the dust ball blowing wash),when the accuracy become poor, please correct or
replace;
Note: In a high temperature and high humidity environment, if excess condensate may be generated in the wine
cabinet, this part of the condensate needs to be manually removed.
JC5 in this series of products are self-absorbent products. The self-absorbent wet film inside is a consumable
part. It needs to be replaced at least once every six months.
The replacement steps are as follows:
1. Turn off the unit and cut off the power, no need to move the unit out of the cabinet. As shown in Figure 6,
loosen and remove the 4 related screws of the fan assembly and set the fan aside to reinstall once the wet film
pad has been replaced.
2. Take out the old wet film pad as shown in Figure 7 and put in the new pad. Note that the direction and
placement of the pad must be the same as the original one, the wet film should be flat and without bending and
deformation, otherwise it will directly affect the moisture absorption effect.
Figure 6 Figure 7
Maintenance