3
3.2 Rear Panel
1 EDID Control switch: Default factory setting is TV, leave as if the display is
properly. Switch to STD to use build-in EDID if the display has problems.
When switch to TV mode, the unit will detect the first HDMI output
source’s EDID and record in the unit. If the first detected output source is
DVI it will pass to next source, until the first HDMI has been detected.
[Note]: EDID control switch will be valid when re-power on the unit.
2 Deep Color switch: Switch between 8 bit or 12 bit Deep Color output.
3 System Reset: Switch to “ON” stage, the system will send the internal
CEC command to the display within 8~10 minutes to force all the
displays switch to HDMI 1 port. Meanwhile, the source CEC command
will not functional to the system. When switch to “OFF” stage, the system
reset function will terminate.
4 HDMI Input: Connect input port to the HDMI or DVI output of your source
equipment such as DVD player or set-top-box.
5 CAT6 outputs: Connect each of the Video/DDC output ports to the
CAT6 to HDMI receiver and then to the display.
6 Power: Plug the 5V DC power supply into the splitter and connect the
adaptor to AC wall outlet.
2
HDMI IN
VIDEO 1
DDC 1
VIDEO 2
DDC 2
VIDEO 3
DDC 3
VIDEO 4
DDC 4
VIDEO 5
DDC 5
VIDEO 6
DDC 6
VIDEO 7
DDC 7
VIDEO 8
DDC 8
DC 5V
TV
STD
12 Bit
8 Bit
OFF
ON
HDMI CAT 6 OUT
SYS. Reset
1 3 4
5
6
