RES-32XR3-S for X8DTL-6/6F Installation Manual
2-4
Themis Computer
When installing memory, follow these rules for best memory performance:
• It is strongly recommended that you
do not mix memory modules
of different
speeds, sizes, and vendors.
2.1.2.1 Installation
The following procedure explains how to install the DDR3 FBD Memory Modules.
1.
on page 2-5, which will loosen the air-
flow diverter so that it can be removed from the system. After the air-flow
diverter has been removed, the memory module slots will be exposed (see
2.
If a module is already seated in the slot you have selected for installation,
remove it by gently pressing down and outward on the latches at both ends of
the slot (see
on page 2-6), then pulling the old module directly up
from the slot until it is free of the connector (see
3.
Before inserting a new memory module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new module verti-
cally into its slot and press firmly downward until it snaps into place.
Table 2-4.
Memory Population for 2CPUs Installed
Memory Population for Optimal Performance
-For a motherboard with Two CPUs installed
CPU1 (To populate P1-DIMMs)
CPU2 (To populate P2-DIMMs)
Branch 0
Branch 1
Branch 2
Branch 0
Branch 1
Branch 2
6 DIMMs
P1-1A
P1-2A
P1-3A
P2-1A
P2-2A
P2-3A
Note:
Make sure the memory module has the proper orientation by align-
ing the alignment notch at the bottom edge with its counterpart ridge at
the bottom of the slot.
