Themis RES-22XR3, Installation Manual, Page: 61 / 162

2-11
Themis Computer
2—Installation and Operation
Installation Procedures
2.1.5.3 Storage-Drive Installation
To install a storage drive,
1. Make sure the latch handle of the drive to be installed is in the open position.
2. Properly orient the new drive and insert it into the vacant drive slot. If the
drive cannot be inserted into the slot, make sure the latch handle is facing you
with the latch hinge oriented to the left and latch lock to the right.
3. Push the drive toward the rear (DO NOT CLOSE the latch handle while push-
ing) until the drive is flush with the front of the chassis. The handle will swing
closed when it comes into contact with the RES-22XR3 chassis.
4. When the drive is fully inserted in its slot, insert the key into the barrel lock
and turn it 45 degrees counter-clockwise. The drive is now locked.
5. If you are installing another storage drive, repeat Steps 1-4 for each additional
drive.
Figure 2-10. RES-22XR3 Storage Drive Removal
Insert key into barrel lock and turn
A
... push the latch lock,…
B
Latch
Lock
Latch Handle
… and pull drive out with the latch handle
C
45 degrees clockwise,…
Barrel
Key
Caution: When in the closed position, the latch handle secures the drive to the
chassis. If the handle is closed before the drive is fully inserted, the latch mechanism
may not fully engage to secure the drive.