16
8.
Finished! Access the Thecus IP storage Web Administrator Interface by
pressing the
Start Browser
button. You can also configure another Thecus
IP storage at this point by clicking the
Setup Other Device
button. Press
Exit
to exit the wizard.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your Thecus IP
storage for use on your network. Setting up the Thecus IP storage typically follows
the five steps outlined below.
For more on how to use the Web Administration Interface, see
Step 1: Network Setup
From the Web Administration Interface, you can configure the network settings of
the Thecus IP storage for your network. You can access the
Network
menu from
the control panel.
For details on how to configure your network settings, refer to
Chapter 4:
System Network
.
Step 2: RAID Creation
Next, administrators can configure their preferred RAID setting and build their
RAID volume. You can access RAID settings from the control panel of the Web
Administration Interface by navigating to
Storage Management > Disk and
RAID.
For more information on configuring RAID, see
Chapter 4: Storage >
Disk and RAID Management
.
Don’t know which RAID level to use? Find out more about the different RAID levels
from
Appendix
B
: RAID Basics
.
Step 3: Create Local Users or Setup Authentication
Once the RAID is ready, you can begin to create local users for Thecus IP storage,
or choose to setup authentication protocols such as Active Directory (AD).
NOTE
The Thecus Setup Wizard is designed for installation on systems running Windows
XP/2000/vista/7/8/10 or Mac OSX or later. Users with other operating systems
will need to install the Thecus Setup Wizard on a host machine with one of these
operating systems before using the unit.
Summary of Contents for N2810 Series
Page 1: ...OS7 User s Manual...
