4
- Deactivating the brightness measurement (the bright-
ness has no influence)
- Channel A lighting always switches with presence/
absence.
"SendoPro 868-A" Management remote control, "the-
Senda P" installation remote control
Measurement
off
Button
Time delay channel A light
Value range
Adjustable values with "SendoPro 868-A" manage-
ment remote control
In the "theSenda P" installation remote control, the
following values are available
10 s - 60 min
10 s, 30 s, 60 s, 2
min, 10 min, 20 min,
60 min
Control for staircase light timer switch
(0.5 s "on" / 10 s "off")
"SendoPro 868-A"
"theSenda P"
Pulse
Button
1
Time delay channel H Presence
The presence channel switches on the basis of the presence
(without brightness as a factor). The relay contact opens once
the room is vacated after the set time delay expires.
Value range
Adjustable values "SendoPro 868-A"
10 s ... 120 min.
Adjustable values "theSenda P"
10 s, 30 s, 60 s, 2
min, 10 min, 20 min,
120 min
Detection sensitivity
The detector has 5 sensitivity increments. The basic setting is
the middle level (3).
By selecting the operation mode test presence, the set sensi-
tivity increment is not changed.
With the „SendoPro 868-A“ management remote control,
levels 1 to 5 can be selected and sent to the detector.
With the „theSenda P“ installation remote control, the sen-
sitivity can be reduced or increased by one level with every
button press.
Level
Sensitivity
1
very insensitive
2
insensitive
3
Standard
4
sensitive
5
very sensitive
Group address channel A light
This parameter is applied when using the „theSenda P“ user
remote control.
A group address can be assigned to the channel A light.
The „SendoPro 868-A“ or „theSenda S“ can be used to pro-
gram the group addresses in the detector.
Group address value range
Adjustable values "SendoPro 868-A"
I, II , III , All
Adjustable values "theSenda S"
I, II
LED display motion
The motion detection can be displayed via the LED.
Value range
No display of motion detection.
Off
The LED switches on when motion is detected, otherwise swit-
ches off.
On
Adjustment possible only with „SendoPro 868-A“.
Factory settings
The theMova P360-101 motion detector is supplied with the
following parameter values:
Parameter
Value
Brightness switching value Channel A light
300 lux
Lighting time delay
10 min
Presence time delay
10 min
Detection sensitivity (PIR)
Stage 3
Group address channel A light
T
LED display motion
Off
9. Start-up
Switching behaviour
Every time the power supply is switched on, the motion
detector first runs through a start-up phase of 30 s, and then
switches to normal operation. A LED displays the current
status:
1. Start-up phase (30 seconds)
•
The red LED flashes every second, both switch contacts
are closed (light and presence on).
•
The detector does not react to remote control commands.
•
When no one is present both contacts open after 30
seconds.
2. Operation
The detector is ready for operation (LED off).
Test detection area
The test mode detection area is used to test presence detec-
tion and wiring. Presence test mode can be activated with the
„SendoPro 868-A“ management remote control and with the
„theSenda P“ installation remote control.
