Theatrelight CUEMASTER, Quick Operation

Page: 19 / 94

CUEMASTER OPERATION 11
CUEMASTER SET-UP
The Cuemaster has a 110/230 volt power select switch on the back panel. Check that the switch is correctly set for your mains supply.
Plug up a correctly wired DMX-512 cables between the Cuemaster and the dimmers, and power up the dimmers and the desk. The
Cuemaster powers up in the state in which it was last turned off—for a clean start, set the following:
1 Set all Channel and Scenemaster faders DOWN.
2 Set the Channels, Park, Scenes, Scene Fade, and Grand Master faders UP.
3 Set the Speed Master down (at Step Mode).
4 If the Kill LED is on, press the Kill key to turn the LED off.
5 If the Chase Rev LED is on, press the Chase Rev key to turn the LED off.
6 If the Cue Back LED is on, press the Cue Back key to turn the LED off.
7 If the Solo/ Latch LED is on, press the Latch key once or twice to turn the LED off.
8 If the Channels Latch LED is on, hold the Latch key, then touch the Chns Flash key to turn the LED off.
9 If the Compare LED is on, hold the Compare key, then touch the Up key to turn the LED off.
10 Press Page Up or Page Down to select Page 1 in the Page display.
11 Press the Park Park key to clear levels stored under the Park master.
THIS PROCEDURE IS NECESSARY FOR CORRECT OPERATION OF THE EXAMPLES ON THE FOLLOWING PAGES

The symbols opposite are used to describe operation on the the following pages.