FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
THE LÜFTEN
TWIN COLUMN TABLE
ASSEMBLY INSTRUCTIONS
THE LÜFTEN
TWIN COLUMN TABLE
ASSEMBLY INSTRUCTIONS
FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
1 / 4
4 / 4
INCLUDED HARDWARE PACKAGE
INCLUDED TOOLS
PLEASE REVIEW
these instructions completely
and verify all parts are included in this package
before beginning assembly. Do not discard
the packaging until satisfied that the product
operates properly. Assembly and operation
of this desk must be in accordance with these
assembly instructions to avoid the risk of injury.
Keep these Assembly and Operation Instructions
near the assembly for reference.
REQUIRED TOOLS
Boden Cord Clip (1)
Glides (4)
OPTIONAL
Castors (4)
Socket Head
Cap Screw (8)
Flat Head
Cap Screw (8)
1/2” Wood
Screw (5)
1” Wood
Screw (8)
m6
Allen Wrench
m8
Allen Wrench
#2 Phillips Head
Screwdriver
1/2” Wrench
“Note” Ideal weight capacity range for the Luften desk is 15-35lbs with a standard 350N spring.
The table support is
solely intended to serve the purpose of ergonomic adjustments for your desk in accordance with the weights and measurements
given in these instructions. Any usage other than that mentioned in this document is inappropriate; the manufacturer disclaims
liability for any resulting damages. In such cases the user bears the full risk. The manufacturer cannot be held responsible for
any losses or damages resulting from unauthorized modifications of this desk.
5
Glides (4)
OPTIONAL
Castors (4)
1/2” Wrench
OPERATING INSTRUCTIONS
To adjust the height of the table, squeeze the release handle and allow table to move up or push down
on table top to lower. To cause more or less tension when lifting and lowering the table, use a wrench to
tighten or loosen the ADJUSTMENT BARREL attached to the end of the handle.
CAUTION: Brace the top with free hand when moving the table up and down to control movement.
• Twist in the GLIDES
or the (OPTIONAL)
CASTORS into the
holes on the bottom
of the base.
• If not secure
enough, tighten with
WRENCH.
Adjustment Barrel
Adjustment Barrel
For proper cleaning instructions go to
TheStandingDesk.com/clean