Instruction Manual
Manual De Instrucción
Manuel D'instruction
Please read before using this unit.
Lea antes de usar esta unidad.
Veuillez lire avant d'utiliser cet appareil.
SMB-553
553-0704-ENG-SPA-FRE02
6601 Lyons Road, Bldg. A7, Coconut Creek, FL33073-9902, USA. OEM088WA5511
TEL: (954) 596-1000 FAX: (954) 596-2000
The Singing Machine Company, Inc.
www.bratz.com
TM & MGA Entertainment, Inc.
All Right Reserved. Used under license by
The Singing Machine Co., Inc.
©
!
MICROPHONE AND SPEAKER WITH DISCO LIGHTS AND SOUNDS
!
MICRO ET HAUT-PARLEUR AVAC LUMIÈRES DISCO ET SONS
!
MICROFONO Y ALTAVOCES CON LUCES DISCO Y SONIDO
RHYTHM SELECTION
AUX IN
MIC IN
STOP
POWER
FUNCTION LIST
1. FUNCTION SELECT
2. RHYTHM 1
3. MASTER VOLUME
4. RHYTHM 2
5. STOP
6. SPEAKER
7. DEMO/PLAY
8. AUX IN
9. MIC IN
10.DISCO LIGHTS
1. Unscrew battery door.
2. Open battery door.
3. Install 6 “AA” batteries.
4. Close battery door and replace screw.
BATTERY INSTALLATION
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1.
Use only the size and type of batteries specified.
2.
Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3.
Do not mix different types of batteries together (e.g. Alkaline and Carbon Zinc) or old batteries
with fresh ones.
4.
If the device is not to be used for a long period of time, remove the batteries to prevent damage
or injury from possible battery leakage.
5.
Do not try to recharge batteries not intended to be recharged, they can overheat and rupture
(Follow battery manufacturer’s directions).
6.
Rechargeable batteries are to be removed from the product before being charged.
7.
Rechargeable batteries are only to be charged under adult supervision.
8.
Exhausted batteries are to be removed from the product.
9.
The supply terminals are not to be short-circuited.
ENGLISH
VISIT OUR WEBSITE www.singingmachine.com
PRINTED IN CHINA
7
8
9
1
2 3 4 5 6
10
DISCO LIGHT
Insure the system is in “PLAY” mode prior to use. The “DEMO” mode is for demonstration
purposes only.
IMPORTANT!
By sliding the FUNCTION switch (#1 on the illustration) from “OFF” to either “Light(ON)” or the
“Light(OFF)” position will allow the system to power “ON”.
By pressing “RHYTHM 1” (#2 on the illustration) or “RHYTHM 2” (#4 on the illustration), 12 different disco
rhythms can be selected. Each button consists of 6 rhythms. You can control the volume level by switching
the “MASTER VOLUME” to “HIGH”, “MID” or “LOW”. Also, you can stop the rhythms by pressing the
“STOP” button.
By inserting AUX/MP3 music plug to “input” jack of AUX IN (#8 on the illustration), you can play your
favorite music. You can also control the volume level by switching the “MASTER VOLUME” to “HIGH”,
“MID” or “LOW”.
For use of the microphone insure the microphone plug is inserted into the jack (#9 on the illustration), slide
the switch on the microphone to the “ON” position.
By pressing the Stop key (#5 on the illustration), it will stop playing rhythm.
Reminder: Please turn the system “OFF” when not in use by sliding the power switch to the OFF
position (#1 on the illustration).
When sliding the switch to the “Light(ON)” position (#1 on the illustration) the item will produce a disco light
effect. The 4 beautiful lights will rotate and project on the ceiling.
The pictures are:
The 4 disco lights (#10 on the illustration) can be switched off sliding the FUNCTION switch to
“Light(OFF)”.
