Lighting Instructions
LIGHTING INSTRUCTIONS
1.
Set all control knobs to off.
2.
Open the lid. The lid must always be open when lighting the grill.
3.
Open the gas valve of the gas cylinder.
4.
Push the knob of the desired burner in and turn it to the left. The
burner will ignite automatically.
5.
Wait until the burner is lit, then the next burned may be lit with the
same procedure.
Ignite the rest of the burners the same way as needed.
TIPS:
Preheat the BBQ for about 10-15 minutes on maximum temperature.
After completion of preheating, turn all burners to the “LO“ position for
best cooking results.
If the burners do not ignite after 5 seconds, set all control knobs to off
(red bar pointing upwards) and close the gas valve of the gas cylinder. Wait
for 5 minutes. Repeat the above procedure.
MANUAL LIGHTING
If the electric ignitor of the appliance does not work or you like to light the
appliance manually using a long match or a fireplace lighter:
Do not lean over the grill while lighting!
1.
Set all control knobs to off (red bar pointing upwards).
2.
Open the lid.
3.
Open the gas valve of the gas cylinder.
4.
Light a long match or long lighter and
enter it into the burner ports on the left or
right sidewall of the firebox.
5.
Push the control knob of the adjacent
burner in, and turn it to the left.
6.
Make sure the burner lights and stays lit.
7.
Adjacent tube burners can be lighted by
pushing their knobs in and turning them to the left.
If the burners do not ignite after 5 seconds, set all control knobs to off (red
bar pointing upwards) and close the gas valve of the gas cylinder. Wait for 5
minutes. Repeat the above procedure.
●
IF THE BURNER DOES NOT IGNITE, TURN THE SWITCHES TO THE OFF POSITION
(CLOSE THE GAS SUPPLY) AND WAIT 5 MINUTES BEFORE TRYING TO IGNITE AGAIN.
●
IF THE GRILL STILL DOES NOT LIGHT WITH NORMAL OR MANUAL METHOD, READ
THE TROUBLESHOOTING TABLE OR CONTACT YOUR DEALER.
!
19
fccbbq.com
