Chapter 5: Configuration Items
psesh:>sysconf etnetcfg show
etnetserver is running
Current etnetserver configuration
ET_HSM_NETSERVER_OLD_WORKER_COUNT=5
ET_HSM_NETSERVER_V2_WORKER_COUNT=12
ET_HSM_NETSERVER_READ_TIMEOUT_SECS=40
ET_HSM_NETSERVER_WRITE_TIMEOUT_SECS=40
ET_HSM_NETSERVER_CONN_TIMEOUT_COUNT=5
ET_HSM_NETSERVER_FRAG_SIZE=5000
ET_HSM_NETSERVER_ALLOW_RESET=OnHalt
ET_HSM_NETSERVER_PORT=12396
ET_HSM_NETSERVER_LOG_CHANNEL=0
ET_HSM_NETSERVER_LOG_NAME=etnetserver
ET_HSM_NETSERVER_LOG_LEVEL=0
Command Result : 0 (Success)
PCI Mode Client Configuration Items
Currently, there is only one modifiable configuration item for PCI mode.
NOTE
Thales recommends leaving configuration items at the their default value or setting
them to a valid value specified in the following table. If the value of a configuration item must
be changed and no valid values are given, contact
for assistance.
For more information about using configuration items see
"Configuration Items" on page 87
Configuration Item
Meaning
ET_HSM_PCICLIENT_READ_TIMEOUT_SECS
Determines the time in seconds the PCI driver will wait before timing
out on a read operation. It should be set long enough to avoid an
unintentional timeout, which causes the driver to shut down the
HSM.
The default timeout should be long enough for general use. The value
should only be modified if the client-side application is expected to
wait for a longer duration, as in the case of key entry on a PIN pad.
Default=
600
Network Mode Client Configuration Items
The available client configuration items for Network mode and their default values are listed in the following
table.
Thales ProtectServer 3 HSM and ProtectToolkit 7 Installation and Configuration Guide
2021-06-30 10:29:48-04:00 Copyright 2009-2021 Thales Group
91