IOM CRUZcontrol® Generation2 for NBC
P/N: 1118211
Revision Date: 05/31/2019
Page
15
of
66
Chapter 4: CRUZ
CONTROL
C
ONCEPT
The CRUZcontrol product line is a set of components used to setup accumulation and discharge on
NBC conveyor. It consists of logic modules that detect product that control accumulation, function
modules that release product, and 24VDC power supplies. There are accessories such as sensors and
cables to ease installation and interfacing.
CRUZcontrol is a 24VDC system that will automatically start accumulation when product reaches the
end of an accumulation line. When a release signal is applied to a function module that is installed at
the discharge end of an accumulation line, the product will begin to release. Product will continue to
release until the signal is removed. The type of accumulation that occurs is based on the mode that the
logic assembly has been configured for. The type of product release is based on logic assembly mode
and function module setup.
Figure 1: Basic Concept Layout
