TGW CRUZbelt, Installation, Operation & Maintenance Manual

Page: 19 / 94

CRUZ
®
belt IOM
P/N: E0032544 Revision Date: 03/14/2019 Page
19
of
94
5.5: P
ART
I
NVENTORY
& I
DENTIFICATION
Label Identification
Each subassembly is shipped completely assembled except typical loose parts, which are in boxes with
the subassemblies. Separate the conveyor subassemblies by types for inventory and ease of locating
during installation.
An identification label is attached to the charged end of the center bed of each CRUZbelt Module unit.
Labels may contain the following information:
• Item number
• Description
• Job Number
•
Mfg. Number
•
Tag number (if specified)
•
Assembler's clock number
•
Date of manufacture
•
QR (Quick Response) bar code
o
Scan bar code for IOM manual
Scan the QR code to retrieve the IOM Manual, if nothing happens; check your scanner settings to make
sure the QR Label setting is enabled.
On the supports, the tag is located on the bottom side of the foot.
On special devices, it is located on a convenient flat surface that is not offensive to the appearance of
the equipment but is still accessible for viewing. These numbers can be cross-referenced against the
packing list.
Loose parts are boxed and shipped separately.
You should have all conveyor sections and supports for a particular conveyor prior to installation. It is
cost-effective to identify and procure any missing parts before they are needed for assembly.
Small items like nuts and bolts are weigh-counted and packaged by size and type.