www.tgogc.com
2
1
2
www.tgogc.com
17
Leg Press/Bench -
TGO951
The Maintainer should perform the following checks and actions to the equipment:
General Regular Visit:
•
Remove graffiti from paint and signage with non-abrasive cleaners (tested for suitability)
•
Inspect and report any damage to signage
•
Inspect and report any damage to components
•
Visually check for loose components or missing fixings
•
Check tightness of all fixings. If loose ensure these are retightened
•
Run the traveller over the full range of movement unloaded and loaded, note and report any
problems, noise or stiffness
•
Touch up any paint damage
Quarterly (compulsory):
•
Perform all general regular visit maintenance listed above.
•
Operate the machine and identify if there are any issues such as noises or stiffness. Try and
diagnose where this is coming from and resolve via maintenance oil or adjustment if possible. If this
problem cannot be resolved, leave the product safe and seek advice from TGO office info@tgogc.
com
•
Inspect the visible stop wedges for any damage and report, replace if necessary
•
Spray all moving parts (joints only) with a suitable maintenance oil (not penetrating oil)
•
Clean the tracks with a light oil based cleaner to prevent fouling
•
Oil the track with a 3in1 maintenance oil
•
Grease the diagonal surfaces of the brake stops
•
Remove traveller if necessary to access polyurethane wheels and other parts
•
Clean off any salt deposits
•
Log quarterly site maintenance visit
Traveller stops and wheel replacement:
•
The traveller stops and polyurethane traveller wheels
[see image label 1]
are considered to be
service parts and are not covered under the terms of the warranty.
Seat & back pad replacement:
•
Saddles and seat pads
[see image label 2]
are considered to be service parts and are not covered
under the terms of the warranty for wilful damage or vandalism. The correct saddles and seat pads
can be supplied by TGO
Handle replacement:
•
Soft handles are considered to be serviced parts. The maintainer should have a stock of handles.
The handle should be cleaned to remove surface contamination. A small amount of adhesive (TGO
can supply appropriate glue) should be applied to the inside of the handle and to the machine
handle, the handle can be rotated onto the arm to give the glue a good coverage in the process. The
handle will be at risk of removal until the glue cures.
