©Copyright Task Force Tips LLC 2021
9
LIY-350 January 13, 2021 Rev00
4.2 INDICATOR LIGHT
The Radius Monitor dash light system indicates when the Radius is not stowed while the truck is running. This will help prevent hitting
low overhanging objects when the Radius in in the deployed position.
4.2.1 INDICATOR SENSOR AND MAGNET MOUNTING
1. Place the monitor in the desired stowed position for both side-to-side and
elevation.
2. Secure the sensor to the monitor’s inlet as shown in figure 4.2.1.
3. Secure the magnet to exit elbow as shown in figure 4.2.1.
4. Verify that the magnet is close enough to the magnetic switch to cause it to
close.
4.2.2 INDICATOR WIRING
1. Mount the dash light by pushing it though a ½” diameter hole in the dash.
2. Assure there is enough room around the light for one of the warning labels.
Figure 4.2.2A
3. Mount the relay in a suitable location. The enclosed relay MUST BE USED to limit the current through the switch.
4. Wire the system as show below.
Figure 4.2.2B
NOTICE
Relay and light available for 12 or 24 volt systems. Voltage is specified at time of order.
NOTICE
The system should only be energized when the truck’s ignition is on.
Magnet
Secure with Stainless
Steel Wire Tie (Y3534)
Magnet Switch
Secure with
Band Clamp (Y3506)
Figure 4.2.1
When Light is ON,
Deck Monitor is
Lower Before
Moving Vehicle.
EXTENDED.
XG
L0
2
0
WARNING
XGL025
WARNING
When Light is ON,
Deck Monitor is
EXTENDED.
Lower Before
Moving Vehicle.
Attach the warning label (XGL020) next to the indicator light
or warning label (XGL025) around the indicator light on the
truck dashboard.
V4155 Relay 12VDC
15VDC Max
10 Watt Coil Max
RADIUS MONITOR
SWITCH
MOUNT RELAY ON
ELECTRICAL PANEL
BATTERY
SPARE
CIRCUIT
BREAKERS
87
86
85
30
87a
SWITCH IS CLOSED WHEN
MONITOR IS IN THE DOWN POSITION
MOUNT PANEL
LIGHT IN DASH
RELAY
