©Copyright Task Force Tips LLC 2021
23
LIX-575 June 24, 2021 Rev00
9.0 MOUNTING THE MONITOR
A Task Force Tips Crossfire
®
monitor may be mounted in one of two ways. We recommend that it be mounted directly on Extend- A-Gun
model XGC38VL-XL, which has an integral Crossfire base built in. Alternatively, it can be mounted on Extend-A-Gun model
XGC38VL-PL using Task Force Tips part XFF-APL Truck Mount Base, which fits only the Task Force Tips Crossfire.
A Task Force Tips Radius
®
monitor may be mounted directly to an Extend-A-Gun with a -PL outlet.
A Task Force Tips monitor with an –RL inlet may be mounted directly to an Extend-A-Gun with a –RL outlet.
Any monitor with a 3” NPTF inlet may be mounted directly to an Extend-A-Gun with a –PL outlet.
Any monitor with 3” 4-Bolt ANSI flange inlet may be mounted to an Extend-A-Gun with a –PL outlet with the addition of an XFF-CPL
Companion Flange Kit.
9.1 TWO PIECE CLAMP ROTATIONAL LOCK INSTALLATION FOR -RL OUTLETS
Task Force Tips monitors with -RL inlet are attached to the Extend-A-Gun VP by a threaded joint with an O-ring seal. The joint between
the Extend-A-Gun VP and monitor is locked rotationally by a two piece clamp rotational lock.
WARNING
Injury or damage can occur from an inadequately supported monitor. The mounting must be
capable of supporting the nozzle reaction force which can be as high as 950 lbs (430 kg).
VSA-125
VSA-125
Y4437
VW360x200-04
Y4435
VT10-32SH1.2
Apply VSA-125 blue Loctite to threads on both
Cylinder Nuts.
MONITOR BASE CLAMP
WASHER
SOCKET HEAD SCREW
10-32 X 1-1/4 LONG
CYLINDER NUT
BLUE LOCTITE
BLUE LOCTITE
STEP 1
STEP 2
Align grooves in heads of Cylinder Nuts with top
sides of Clamps.
Slide Screws through Washers and Clamps.
Loosely thread Screws into Cylinder Nuts.
TOP SIDE OF CLAMP
CYLINDER NUT
HEAD GROOVE
