Textron Stampede 900 2017, Repair And Service Manual

Page: 47 / 237

B
FRAME
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
35
Repair and Service Manual
668061
Seat Frame Removal
Tool List Qty.
Ratchet ........................................................................ 1
Socket, 13mm..............................................................1
Socket, 17mm..............................................................1
Wrench,13mm .............................................................1
Wrench, 17mm ............................................................1
Torque Wrench, ft. lbs..................................................1
1.
Remove the bolts (41) and nuts (42) that secure the
seat frame supports (40) to the seat frame(1) (See
Fig. 6).
2. Remove the bolts (30) and nuts (31) that secure the
seat frame (1) to the B-pillar crossmember (32).
3. Remove the bolts (27) and nuts (28) that secure the
seat frame (1) to the B-pillars on each side of the
vehicle frame.
4. Remove the bolts (10) that secure the legs of the
seat frame (1) to the vehicle frame. Remove the seat
frame from the vehicle.
5. Installation is in the reverse order of removal.
6. Tighten hardware to the torque specified below:
B-Pillar Crossmember Removal
Tool List Qty.
Ratchet ........................................................................ 1
Socket, 13mm..............................................................1
Socket, 17mm..............................................................1
Wrench,13mm .............................................................1
Wrench, 17mm ............................................................1
Torque Wrench, ft. lbs..................................................1
1.
Remove the bolts (30) and nuts (31) that secure seat
frame (1) to the B-pillar crossmember (32) (Ref. Fig.
6).
2. Remove the bolts (33) and nuts (34) that secure the
ends of the crossmember (32) to the top of the B-pil-
lars of the vehicle frame. Remove the crossmember.
3. Installation is in the reverse order of removal.
4. Tighten hardware to the torque specified below:
ITEM NO TORQUE SPECIFICATION
10 15 - 16
ft.lbs. (20 - 22 Nm)
27, 28 30 - 33
ft.lbs. (40 - 45 Nm)
30, 31 30 - 33
ft.lbs. (40 - 45 Nm)
41, 42 15 - 16
ft.lbs. (20 - 22 Nm)
ITEM NO TORQUE SPECIFICATION
30, 31
30 - 33
ft.lbs. (40 - 45 Nm)
33, 34
30 - 33
ft.lbs. (40 - 45 Nm)