Textron Stampede 900 2017, Repair And Service Manual, Page: 155 / 237

B
ELECTRICAL SYSTEM
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
143
Repair and Service Manual
668061
Voltage Regulator Removal
Tool List Qty.
Wrench, Insulated, 1/2” ............................................... 1
Ratchet ........................................................................ 1
Socket, 10mm ............................................................. 1
Wrench, 10mm ............................................................ 1
1.
Using an insulated wrench, disconnect the wire from
the voltage regulator (2) from the negative (-) battery
terminal.
2. Disconnect the remaining wires from the wire har-
ness.
3. Remove bolts (3), washers (4) and nuts (25) that
secure the voltage regulator (2) to the seat frame.
Remove the voltage regulator.
4. Installation is in the reverse order of removal.
Starter Relay Removal
Tool List Qty.
Ratchet ........................................................................ 1
Socket, 10mm ............................................................. 1
1.
Remove the nuts (25) securing the starter motor
wires to the starter relay (5). Remove the wires from
the relay terminals.
2. Remove the bolts (26) that secure the starter relay
(5) to the seat frame. Remove the starter relay.
3. Installation is in the reverse order of removal.
Solenoid Controller Removal
Tool List Qty.
Ratchet ........................................................................ 1
Socket, 15mm ............................................................. 1
Screwdriver Phillips Head ........................................... 1
1.
Disconnect the wire from the solenoid controller (6).
2. Remove screws (7), washers (9) and nuts (8) that
secure the solenoid controller (6) to the seat frame.
Remove the solenoid controller.
3. Installation is in the reverse order of removal.