Textron Stampede 900 2017, Repair And Service Manual, Page: 102 / 237

B
90
Repair and Service Manual
REAR AXLE AND SUSPENSION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
7. Remove the nuts (20) and bolts (7) that secure each
side of the lower control arm (2) to the vehicle frame
(Ref. Fig. 1)(Ref. Fig. 11).
Fig. 11 Lower Control Arm
8. Remove the lower control arm from the vehicle.
9. Installation of lower control arm assembly is the
reverse of removal.
10. Tighten the hardware to the torque values specified
below:
Upper Control Arm Assembly Replacement
Tool List Qty.
Wheel Chocks .............................................................4
Floor Jack ....................................................................1
Jack Stands .................................................................4
Plastic Faced Hammer ................................................1
Wrench, 15mm ............................................................1
Wrench, 17mm ............................................................1
Wrench 18mm ...............................................................
Wrench 19mm .............................................................1
Socket, 15mm..............................................................1
Socket, 17mm..............................................................1
Socket,18mm...............................................................1
Socket, 19mm..............................................................1
Ratchet ........................................................................ 1
Torque Wrench, ft. lbs..................................................1
1.
Lift and support vehicle. See LIFTING THE VEHI-
CLE on page 13.
2. Remove the wheel. See Wheel Removal on page 54.
3. Remove the brake calipers from the rotor. See Brake
Pad Replacement on page 60.
4. Remove the hub. See Hub Removal on page 86.
5. Remove the rear spindle. See Rear Spindle Removal
on page 87.
6. Remove the rear strut assembly. See Rear Strut
Assembly Replacement on page 89.
7. Remove the nut (25) and bolt (24) that secure the
stabilizer link (30) to the upper control arm (1) (Ref.
Fig. 1). Check the rubber bushings for deterioration.
Fig. 12 Upper Control Arm
8. Remove the nuts (20) and bolts (7) that secure each
side of the upper control arm (1) to the vehicle frame
(Ref. Fig. 12).
9. Remove the upper control arm from the vehicle.
10. Installation of upper control arm assembly is the
reverse of removal.
11. Tighten the hardware to the torque values specified:
Stabilizer Bar Removal
Tool List Qty.
Ratchet.........................................................................1
Socket, 19mm ..............................................................1
Socket, 15mm ..............................................................1
Wrench, 19mm.............................................................1
Wrench, 15mm.............................................................1
Torque Wrench, ft. lbs. .................................................1
Item Torque Specification
7, 20 40 - 44 ft. lbs. (54 - 60 Nm)
20
7
2
Item Torque Specification
24, 25 70 - 77 ft. lbs. (95 - 105 Nm)
7, 20 40 - 44 ft. lbs. (54 - 60 Nm)
1
24
25