Textron Jacobsen HR-5111, Technical/Repair Manual

Page: 194 / 423

5-30 4203780 First Edition
HYDROSTATIC POWER TRAIN
5
Reverse Kick-Out Switch Initial Adjustment
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
Figure 5-15
NOTES
• Remove floorboard plug to access reverse kick-out
switch (1).
• Label all wires before disconnecting to ensure correct
installation.
3. Disconnect wire connector (2) and connect test leads
to the reverse kick-out switch terminals.
The reverse kick-out switch should indicate continuity
when the traction pedal is in the forward or neutral
position. The reverse kick-out switch should not indicate
continuity when the traction pedal is in the reverse
position.
If adjustment is required, proceed to step 4. If no
adjustment is required, proceed to “Reverse Kick-Out
Switch Adjustment” on page 5-31.
Figure 5-16
4. Loosen nuts (3 and 6).
5. Position switch bracket (4), and reverse kick-out
switch (5) to achieve continuity when the traction
pedal is in the neutral position and the 4WD switch is
in the ON position and no continuity when the traction
pedal is in the reverse position.
6. Tighten nuts (1 and 4) and install floorboard plug.
7. Proceed to “Reverse Kick-Out Switch Adjustment” on
page 5-31.
Required Tools or Equipment
Digital Multimeter, Ohmmeter, or Continuity Tester
TN1915
2
1
TN2140
4
5
3
6