Textron Jacobsen HR-5111, Technical/Repair Manual, Page: 137 / 423

ELECTRICAL
4203780 First Edition 4-87
4
6. Remove fan drive belt (9) from alternator pulley.
7. Support the alternator (3).
8. Remove screw (8), lock washer (7), and flat washer
(6).
9. Remove screw (5) and nut (4).
10. Remove alternator (3).
Installation Notes
• Install the alternator by reversing the order of
removal.
• Adjust fan belt tension. (Refer to “Safety, Operation &
Maintenance Manual”.)
Starter Motor
Removal and Installation
See Figure 4-59.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Raise the hood.
3. Disconnect the negative (–) battery cable at the
battery.
Figure 4-59
NOTE
Label all wires before disconnecting to ensure correct
installation.
4. Disconnect wire connectors (4, 5, 6, and 7) from the
starter motor (1).
5. Support the starter motor (1).
6. Remove screw (3) and nut (2).
7. Remove starter motor.
Installation Note
Install the starter motor by reversing the order of removal.
Circuit Breakers
Removal and Installation
See Figures 4-60 and 4-61.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
3. Remove instrument panel. (See “Instrument Panel”
on page 4-110.)
Figure 4-60
4. Remove nut (1).
Figure 4-61
NOTE
Label all wires before disconnecting to ensure correct
installation.
5. Disconnect wire connectors (3 and 4).
6. Remove circuit breaker (2).
Installation Note
7. Install the circuit breaker by reversing the order of
removal.
TN2025
7
2
6
1
5
4
3
TN1990
1
TN2030
2
3
4