SERVICE KIT
SK208-166
10.
(Refer to Figure 1, Detail A.) Install the new quadrant cover assembly. (Refer to the Maintenance Manual,
Chapter 76, Quadrant Assembly and Controls - Maintenance Practices.)
A.
(Airplanes without ETM installed) Install shear wire and quadrant cover.
(1)
Use the kept control column cover as a guide and mark the shear-wire hole location on the
new 2613048-22 Cover Assembly (standard) or 2601455-13 Guard and 2601455-18 Cover
Assembly (British).
(2)
Match drill a 0.172-inch diameter hole through the cover. British Certi
fi
ed airplanes, enlarge the
hole in the 2601455-18 Cover Assembly only to 0.438 inch diameter. Deburr the hole.
(3)
Apply Alodine to the hole.
(4)
Reinstall the kept screw, washer and one new MS21042L08 Nut in the new hole.
(5)
Install the 2613048-22 Cover Assembly (standard) or 2601455-18 Cover Assembly (British)
with the 2601455-13 Guard Assembly and the kept screws.
(6)
Install one C489003 Wire, cut to length, with the double-twist method around the emergency
power lever. (Refer to the Maintenance Manual, Chapter 20, Safetying - Maintenance
Practices.)
B.
(Airplanes with ETM installed) Install the 2613048-22 Cover Assembly (standard) or 2601455-18
Cover Assembly (British) with the 2601455-13 Guard and the kept screws.
C.
Install the kept knobs on the new levers with the kept hardware.
11.
Remove maintenance warning tags and connect the airplane battery.
12.
Make an entry in the airplane logbook stating this Service Kit has been installed.
SK208-166
Page 5
