69
Default
The beeper is enabled when it is shipped from the factory. The beeper state is stored in
a volatile memory and the default will be restored when the meter has been turned off or
after a remote interface reset.
How to control the beeper
User can control the beeper from either the front panel operation or the remote interface
operation.
Front Panel Operation
Follow the procedure below to disable or enable the beeper:
Press MENU button then use
◁
and
▷
buttons to find SYSTEM menu. Press
ENTER to choose it, and then again use
◁
and
▷
buttons to find BEEP menu. Press
ENTER to choose it, and then find ON or OFF
by using
◁
and
▷
buttons. Press ENTER on your selection.
The locations of the buttons
are shown with red rectangle frames in
Figure 4-27
.
Procedures: MENU
→
SYSTEM
→
BEEP
→
{ON|OFF}
Figure 4-27
Remote Interface Operation
The following commands show how to use the remote interface operation to disable or
enable the beeper:
SYSTem:BEEPer
SYSTem:BEEPer:STATe {OFF|ON}
3.4.3 Reading Memory (Store & Recall)
DL-2060 has a memory capacity of 2000 readings. The readings are stored in
first-in-first-out order and the memory type is volatile, which means the stored readings
will be cleared when the multimeter is power-off. The reading memory feature can be
Summary of Contents for DL-2060
Page 37: ...31 Figure 3 17 1 2 3 5 5 4...
Page 136: ...130...
Page 137: ...131...
Page 138: ...132 D DL 2060 s Dimension...
