TEXIO DCS-4605, Instruction Manual

Page: 42 / 117

30
3-1-2. Using Autoset
Background The Autoset function automatically configures the
panel settings to the best viewing conditions, in the
following way.

Selecting the horizontal scale

Positioning the waveform horizontally

Selecting the vertical scale

Positioning the waveform vertically

Selecting the trigger source channel

Activating the channels
Procedure 1. Connect the input signal to
the oscilloscope and press
the Autoset key.
Autoset
2. The waveform(s) appears in the center of the
display.
Undo option
Before Autoset After Autoset
Undoing the
Autoset To undo the Autoset, press
Undo (available for a few
seconds).
Undo
Adjusting the
trigger level If the waveform is still unstable,
try adjusting the trigger level up
or down by using the Trigger
Level knob.
LEVEL
Limitation Autoset does not work in the following situation.

Input signal frequency less than 30Hz

Input signal amplitude less than 30mV