A4 Photo / Paper Trimmer (TTA4-V)
Thank you for choosing a Texet photo/paper trimmer.
Before operating the trimmer, please read and keep the instructions for reference.
Before operating the trimmer
– please read and keep the user instructions for reference.
Parts description: As per below picture indicates:
①
. Cutting head.
②
. Working table base.
③
. Accessible open / close cap for changing blade.
④
. Guide rail / clamp.
Prescribed use
The rotary trimmer is designed for the creative cutting of paper, film and other
suitable soft materials. It is possible to cut up to 5 sheets (70g/mm) at the same
time.
Safety instructions
In case of any damages which are caused due to the failure to observe these
operating instructions, improper operation, or the failure to observe the
safety instructions, the guarantee for this product will be invalid.
●
Do not carry the product at the cutting head.
●
Do not overload the Paper trimmer. Do not insert more sheets or
stronger sheets than stated in the Technical data.
●
Do not touch the edge of the blades as they are very sharp!
●
Please keep this operating manual for further reference!
●
If you pass the device on to third parties, forward this operating
manual as well.
Operation
Do not cut hard material such as metal strips, glass etc. Always operate the
device with both hands. Use the device on a stable, flat and even surface only.
Before each cut please check the Blade in the cutting head is secure.
Place the Paper Trimmer onto a non-slipping surface.
Push the cutting head on one side of the ruler.
Place the material to be cut with the cutting edge under the cutting ruler and
bring it into the desired position.
Press the cutting ruler onto the material to be cut in order to fix it and hold it
with the other hand.
Now, pull the cutting head in a constant movement and with slight downward
pressure along the cutting ruler.
Instruction to change blade
Do not touch the edge of the blades as they are very sharp!
Remove the cap at the back of the cutting head and open by turning lever
towards
“OPEN” (
figure 1
).
Place the cap with the Blade in a safe place so you do not injure yourself
(
Figure 2
).
(Figure 1)
(
Figure 2)
Turn the Paper Trimmer over onto a non-slipping surface.
Remove the required Blade in its protector from under the trimmer.
Carefully remove the blade protection.
Turn the trimmer back over again onto a flat surface.
Insert the new Blade into the cutting head. The axis of the Blade must be
inserted properly into the receptacle of the cutting head (
Figure 3 & Figure 4
).
(Figure 3)
(Figure 4)
Place the cap back onto the cutting head and turn it towards “LOCK” until it
locks into place (
Figure 5
).
Insert the replaced Blade into the blade protector and place it into the support
on the bottom of the base plate.
(Figure 5)
This hand operated trimmer is only suitable for persons aged 16+; persons
over the age of 12 years but under the age of 16, may however use the device
while under the supervision of an adult.
www.texet.com
