Texas Instruments Voyage 200, User Manual

Page: 485 / 1008

Additional Graphing Topics 485
The Y= Editor in Two-Graph Mode The Y= Editor in Two-Graph Mode The Y= Editor in Two-Graph Mode The Y= Editor in Two-Graph Mode
Even in two-graph mode, there is actually only one Y= Editor, which maintains a single
function list for each Graph mode setting. However, if both sides use the same graphing
mode, each side can select different functions from that single list.
• Suppose Graph 1 and Graph 2 are set for function graphing. Although both sides
show the same function list, you can select (
Ÿ
) different functions for graphing
Note:
If you make a change on the active Y= Editor (redefine a function, change a style,
etc.), that change is not reflected on the inactive side until you switch to it.
• When both sides use different graphing
modes, each side shows a different
function list.
• When both sides use the same graphing
mode, each side shows the same function
list.
- You can use
†
to select different
functions and stat plots (indicated
by
Ÿ
) for each side.
- If you set a display style for a
function, that style is used by both
sides.
ˆ