Texas Instruments TRF3703, User Manual, Page: 18 / 22

2.2 Parts List
3 Circuit Description
3.1 Circuit Function
3.1.1 Power
Circuit Description
www.ti.com
Table 1. Bill of Materials for TRF3703 EVM
Value Footprint QTY Part Number Vendor Digi-Key Number REF DES Not
Installed
Tantalum 4.7-
µ
F, 3216 2 T491A475K010AS KEMET 399-1561-1-ND C6, C7
10-V, 10%
capacitor
1000-pF, 50-V, 603 2 ECJ-1VC1H102J Panasonic PCC2151CT-ND C4, C5
5% capacitor
100-pF, 50-V, 5% 603 3 ECJ-1VC1H101J Panasonic PCC101ACVCT-ND C1, C2, C3
capacitor
Capacitor 603 0 C8, C9
0-
Ω
resistor, 603 5 ERJ-3GEY0R00V Panasonic P0.0GCT-ND R1, R2,
1/10-W, 5% R3, R4, R5
TRF3703 24-QFN-PP- 1 TI U1
4X4MM
SMA connectors SMA_END_ 6 16F3627 Newark 142-0711-821 J1, J2, J3,
SMALL J4, J5, J6,
J7
2POS_HEADER 2POS_JUMP 2 HTSW-150-07-L-S SAMTEC N/A W1, W2
This chapter discusses the various functions of the EVM.
•
Headers W1 and W2 supply 5-V V
CC
dc power to the modulator. Header W1 supplies 5 V to the LO
circuitry, and W2 supplies 5 V to the modulator circuitry.
•
Four SMA connectors are provided on the EVM for inputting differential I/Q signals directly to the input
pins of the TRF3703. Connectors J3, J4, J5, and J6 are used to connect the signal source I/Q signals
directly to the TRF3703.
•
Two SMA connectors are provided for LO input: J1 = LOP and J2 = LON. Terminate whichever LO
port is not being used through 50
Ω
to ground.
•
One SMA connector is for RF_OUT: J7.
Table 2. Power Supply J1
J1 Pin Description
W1 5-V (V
CC
), U1 analog supply
W2 5-V (V
CC
), U1 analog supply
18 TRF3703 Quadrature Modulator Evaluation Module SLWU042B – October 2006 – Revised August 2008
Submit Documentation Feedback