Setup
www.ti.com
Figure 3. Starting the Software
Once the used device is selected, the software starts up (see
).
By clicking on the Tabs CHARGER , DCDC1/LDO1, GPIO, and INTERRUPTS, the user can navigate
through the different Views
The window that first appears allows control of all charger settings and shows all the charger status Flags.
In the CHARGER Tab, users can enable/disable the charger and change charger parameters as regulated
output voltage on the Power Path (VSYS), Charge Voltage, Safety Timers, etc.
In the Lower right corner of the window, all charger related User Registers are displayed.
See the TPS65720 data sheet for detailed description on these registers.
8
TPS65720EVM
SLVU324 – March 2010
Copyright © 2010, Texas Instruments Incorporated
