Texas Instruments TPS62851 EVM-139 Series User Manual Download Page 1

User’s Guide

TPS62851xEVM-139 Evaluation Module

ABSTRACT

TheTPS62851xEVM-139 facilitates the evaluation of the TPS62851x 0.5-A, 1-A and 2-A pin to pin compatible 
step-down converters in a 2.1-mm × 1.6-mm (including pins) in SOT583 package. BSR139-001 uses the 2-A 
TPS628512 device, BSR139-002 uses the 1-A TPS628511 device and BSR139-003 uses the 0.5-A TPS628510 
device. The EVMs regulate the output voltage to 1.8 V from input voltage from 2.7 V to 6 V. This user's guide 
describes the characteristics, operation, and use of the TPS62851xEVM-139 Evaluation Module (EVM) with a 
complete schematic diagram, printed circuit board layouts, and bill of materials are included in this document.

Table of Contents

1 Introduction

.............................................................................................................................................................................

2

2 Setup

........................................................................................................................................................................................

3

3 TPS62851xEVM-139 Test Results

..........................................................................................................................................

3

4 Board Layout

...........................................................................................................................................................................

4

5 Schematic and Bill of Materials

.............................................................................................................................................

9

6 Revision History

...................................................................................................................................................................

10

List of Figures

Figure 4-1. Top Silk......................................................................................................................................................................

4

Figure 4-2. Top Layer...................................................................................................................................................................

5

Figure 4-3. Layer 2......................................................................................................................................................................

6

Figure 4-4. Layer 3......................................................................................................................................................................

7

Figure 4-5. Bottom Layer.............................................................................................................................................................

8

Figure 5-1. TPS62851xEVM Schematic......................................................................................................................................

9

List of Tables

Table 1-1. Performance Specifications Summary........................................................................................................................

2

Table 5-1. TPS62851xEVM-139 BOM.......................................................................................................................................

10

Trademarks

All trademarks are the property of their respective owners.

www.ti.com

Table of Contents

SLVUBY6A – AUGUST 2020 – REVISED JUNE 2021

Submit Document Feedback

TPS62851xEVM-139 Evaluation Module

1

Copyright © 2021 Texas Instruments Incorporated

Summary of Contents for TPS62851 EVM-139 Series

















Reviews: