1 Introduction
The TPS3899EVM is an evaluation module (EVM) for the TPS3899 voltage supervisor. The TPS3899EVM can
be used with any TPS3899 device variant but please note that if using the push-pull variants (TPS3899PLXX or
TPS3899PHXX), the shunt on J4 must be removed as push-pull devices do not use a pull-up resistor and R1
must be disconnected. Please also note if using TPS3899EVM with the active-high variant (TPS3899PHXX), the
active-low RESET label on the EVM board and throughout this User Guide becomes active-high RESET. The
TPS3899EVM offers connections for all of the input and output pins on the TPS3899.
Figure 1-1. Board Top
Introduction
2
TPS3899EVM Voltage Supervisor User Guide
SLVUBZ3 – SEPTEMBER 2020
Copyright © 2020 Texas Instruments Incorporated