Texas Instruments TPS2663-166EVM, User Manual, Page: 6 / 17

Test Equipment and Setup
www.ti.com
6 SLVUBQ5A – August 2019 – Revised October 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
TPS2663-166EVM: Evaluation Module for TPS2663xPWP and TPS1663xPWP
5 Test Equipment and Setup
This section lists the required test equipment and provides instructions to set up the tests.
5.1 Power Supplies
Two adjustable power supplies 0-V to 60-V output, 0-A to 10-A output current limit.
5.2 Meters
Testing requires two digital multimeters (DMM).
5.3 Oscilloscope
A DPO2024 or equivalent, three 10× voltage probes, and a DC current probe.
5.4 Loads
Two resistive loads or an equivalent which can tolerate up to 10-A DC load at 60 V and is capable of the
output short.
5.5 Test Setup
Before performing any of the tests listed in Section 6 , setup the EVM as per the following steps:
• Make sure that the jumper settings on the EVM are set to the default position as shown in Table 5 .
• Connect the power supply, load, oscilloscope, and voltmeter to the EVM as Figure 2 shows.
• Set the power supply output to 0 V.
• Turn ON the power supply and set the power supply output to 24 V and current limit to 10 A.
• Turn OFF the power supply.