Texas Instruments TMS320DM6467 DVEVM, Getting Started Manual, Page: 49 / 72

Rebuilding the DVSDK Software for the Target
DVEVM Software Setup 4-17
4.6 Rebuilding the DVSDK Software for the Target
To place demo files in the /opt/dvsdk/dm6467 directory, you need to
rebuild the DVSDK software. To do this, follow these steps:
1) If you have not already done so, rebuild the Linux kernel as described
in Section 4.5.
2) Change directory to dvsdk_#_#.
3) Edit the Rules.make file in the dvsdk_#_#. directory as needed. If you
installed components in the default locations, the directory definitions
may already be correct, but you should verify them in any case.
■
Set PLATFORM to match your EVM board as follows:
PLATFORM=dm6467
■
Set DVSDK_INSTALL_DIR to the top-level DVSDK installation
directory as follows:
DVSDK_INSTALL_DIR=/home/< useracct >/dvsdk_#_#
■
Modify the following variables as needed to match the locations
of these components on your Linux host. We recommend that
these components be installed in the
/home/<
useracct >/dvsdk_#_# directory, but you may have
installed them elsewhere.
XDC_INSTALL_DIR=/home/< useracct >/dvsdk_#_#/xdctools_#_#
FC_INSTALL_DIR=/home/< useracct >/dvsdk_#_#/fc_#_#
BIOS_INSTALL_DIR=/home/< useracct >/dvsdk_#_#/bios_#_#
■
Make sure LINUXKERNEL_INSTALL_DIR is defined as follows:
LINUXKERNEL_INSTALL_DIR=/home/< useracct >/workdir/lsp/ti-davinci/linux-2.6.18_pro500
■
Make sure MVTOOL_DIR points to the MontaVista Linux tools
directory as follows:
MVTOOL_DIR=/opt/mv_pro_5.0/montavista/pro/devkit/arm/v5t_le
■
Make sure EXEC_DIR points to the opt directory on the NFS
exported file system as follows:
EXEC_DIR=/home/< useracct >/workdir/filesys/opt/dvsdk/$(PLATFORM)
4) While in the same directory that contains Rules.make, use the
following commands to build the DVSDK demo applications and put