Texas Instruments TMS320DM6467 DVEVM, Getting Started Manual, Page: 27 / 72

Running the Standalone Demos
Running the Demonstration Software 3-7
The application runs on the ARM using Linux. The video signal is passed
to video encoders and decoders on the DSP by the Codec Engine.
Shared memory is used when passing data.
To use this demo from the command line, see Section 3.4, Running the
Demos from the Command Line .
3.3.3 About the Encode Demo
Like the Decode demo, the Encode demo also encodes 720p
video. In addition, it also encodes audio or speech. The audio/speech
source is the microphone.
The encoded data is written to files on the EVM’s hard disk drive. The
possible filenames are demo_g711.264, demo_aac.264, demo.aac, and
demo.g711. Older versions of these files are overwritten as needed.
Output is not decoded and sent to the display or speakers other than to
show the settings and dynamic data collected about the load and rates.