Installation
2.1.7
Board Power-Up General Guidelines
Connect the MC57xxPSIA and the TAS5717LEVM boards by locating pin 1 on each board, indicated by a
small white triangle. The MC57xxPSIA plugs down onto the TAS5731EVM board (that is, the
TAS5731EVM board fits underneath the MC57xxPSIA board). Pin 1 on each board must be connected to
each other.
Install the EVM software on the PC before powering up the board. After connecting the loudspeakers or
other loads, power supplies, and the data line, power up the 5-V power supply first; then power up the
PVDD power supply.
2.2
Software Installation
Download the TAS57X1 GDE from the TI Web site, located on the TAS5731EVM product page. The TI
Web site always has the latest release and any updates to versions of the GUI.
Execute the GUI install program, Setup.exe. Once the program is installed, the program group and
shortcut icon is created in Start
→
Program
→
Texas Instruments Inc
→
TAS57X1 GDE.
The TAS5717L tab opens when the GUI starts. The TAS5717L tab has two subwindows. One shows the
Process Flow window. This window also shows Input select, Mode select, Channel, and Master Volume.
All functions are shown in the same order as in the device.
The other subwindow, the Properties window, has the properties that a user can update by selecting from
the available options. The properties available depend on the device selected.
7
SLOU331A – December 2011 – Revised August 2014
TAS5731EVM Evaluation Module
Copyright © 2011–2014, Texas Instruments Incorporated
