GND
VOUT
G
N
D
S
VOS
TOP FRONT
BOTTOM FRONT
VIS
VIN
INPUT
SUPPLY
LOAD
(+)
(-) (-)
(+)
(+)
(-)
DMM
DMM
(-)
(+)
Setup
3
SNVU573A – August 2017 – Revised March 2018
Copyright © 2017–2018, Texas Instruments Incorporated
LMR33630 EVM User’s Guide
Figure 2. EVM Card Edge Connections
1.1
Jumpers
Please refer to
for jumper locations.
•
EN -
This jumper allows the EN input to be connected to either ground (OFF) or VIN (ON). Remove
this jumper to allow an external logic signal to control the EN function.
•
VOUT -
This jumper is used to select one of the two pre-defined output voltages. The "3.3V" position
provides a 3.3 V output; while the "5V" position provides a 5 V output.
