Using TI’s USB2ANY Module for In-System Programming of LMK03328
Figure 24. USB2ANY Board Connections
The standard USB2ANY Kit (HPA665-001) includes both a 10-pin cable and a 30-pin cable. The 10-pin
cable is intended to be connected to J4. J4 provides the SDA, SCL, and GND connections of interest.
NOTE:
J5 and J6 supply other connections that are NOT required and therefore, outside the scope
of this document.
When the USB2ANY board is in the enclosure, there is a key notch above J4 that will prevent the cable
connector from being plugged in upside-down. With the notch at the top, pin 1 of the 10-pin cable
connector is located at the upper-right corner.
The 10-pin cable is about 6 inches in length and has a keyed female 10-pin IDC connector on each end.
The cable should be connected to the USB2ANY board as shown in
(note that the key must be
facing up, away from the board). The opposite end of the cable should be connected to the target board.
The red stripe on the cable indicates pin 1 as shown in
48
LMK03328EVM User’s Guide
SNAU184 – August 2015
Copyright © 2015, Texas Instruments Incorporated
